Window sill stone is best to use ceramic tiles

Most people like to install marble on the edge of the window, but if it is improperly cleaned and maintained, it is easy to get dirt or even abrasion. Tiles can reproduce the texture of marble, and subsequent maintenance is relatively simple.

Check the empty drum after paving

There are many hidden dangers of tile hollowing. The gradually expanding hollowing will cause the tiles to lift up or fall off. It will also cause difficulty in drilling the wall in the future and easily break the tiles (for example, when installing water heaters, mirrors, pendants, cabinets, and bathroom cabinets) ).

To check the empty drum, it is not necessary to use a professional empty drum detection hammer. The metal spoon for eating can be substituted. If the sound is dull on the wall and floor, it means that the tiles are firmly attached; on the contrary, a crisp sound of "dong dong" means that the tiles are not firmly laid and there is a hollow drum.

 Wet the ground the day before laying bricks

On the night before you start laying bricks, damp the ground first so that the ground can absorb enough water. Before laying the bricks the next day, moisten the ground again, and finally pave the bricks with cement, which will enhance the adhesion.

The bathroom threshold stone should be edged

Since the door stone of the bathroom requires a certain degree of water retention, it is generally higher than the ground. Pay attention to single or bilateral chamfering and edging, the effect is more beautiful.

Pay attention to plastering when tiling the flue

There are many hidden dangers of tiling in the flue, and it is a common phenomenon that tiles on the flue fall off. Workers can plaster two centimeters on the original prefabricated board, most of which fall off because of the hidden dangers of too thin plastering.

The outlet of the sewer pipe should be closed to avoid blockage caused by dirt entering

   Cover the drain pipe of the bathroom cabinet in the bathroom with some scraps or seal it with a plastic bag. Avoid clogging caused by dirt entering during decoration.

Cut brick size should be good

At the window sills and at the sunny corners, workers must be careful and good size before cutting the bricks. Don't have a big error like my home, and a wide gap flashes with the windows.

Round hole or square hole?

The water outlet on the wall must be cut by workers, and if it is round, cut it into a circle. Don't cut a square hole before it is unsightly. The switch box must be cut horizontally and vertically, and the mud that seeps into the switch box after tiling must be cleaned up in time, otherwise it will be difficult to get rid of it after drying.

Fill the joints between wall tiles and ceiling with cement

The joints between the wall tiles and the ceiling must be filled with cement by the workers, otherwise cracking will occur if the painters are filled with putty later.

Support bones improve the flatness of floor tiles

If there is a slight deviation in the flatness when laying the floor tiles, you can buy the support bones to put the four corners against the tiles, so that the tiles will be flat.

Place tiles where you can't see

Places that are invisible, such as thick sewage pipes, must be tiled behind. If workers refuse to do so on the grounds that the pipe is too close to the wall to reach in, they must not be soft-hearted.

Make a good drawing of the wall

Sometimes due to family needs, the owner wants to divide a house into two spaces, and at the same time, windows and doors are required on the wall. An experienced decorator will draw a graph 1:1 on the wall for research, and use a large core board to cut out door frames, window frames and other templates.